Placeholder · hero 21:9 · Flat lay of acoustic fixings on a felt sheet: a tube of Turbo adhesive, a coiled steel baffle hanging kit and aluminium wall channels with clips

Echo Treatment

Hardware

The fixings our panels go up with: Turbo® adhesive, baffle hanging wires, and aluminium channels and clips.

Shop all hardware See where it goes

Walls: Adhesive, channels and clips
Ceilings: Steel cable hanging kits
Works with: PET, wood and fabric panels

What it is

The right fixing for each panel.

A panel only works if it stays where you put it, flat to the wall or level under the ceiling.

Turbo® adhesive sticks felt and panels straight to the wall. Aluminium channels and clips hold panels you may want to lift off later. Hanging wires drop baffles and clouds below the ceiling.

Order them with your panels so everything arrives together.

Good to know: these are fixings, not absorbers. Pair them with our panels, baffles and clouds.

Where it goes

Pick by the job.

Placeholder · 3:2 · Installer pressing a Reed Green PET sheet onto a plastered wall with adhesive dots on the back

Sheets on a plaster wall

Turbo® adhesive fixes PET sheets and grooved panels flat to a painted wall.

Placeholder · 3:2 · Open-plan office ceiling with rows of grey PET baffles hung on thin steel cables

Baffles over an open office

Hanging wires drop rows of baffles to an even height above the desks.

Placeholder · 3:2 · Meeting room with a single felt ceiling cloud hung on four steel cables above the table

Clouds over a meeting table

The same kits level a ceiling cloud a short drop below the slab.

Placeholder · 3:2 · Fabric-wrapped panel being lifted off aluminium wall clips in a rented office

Panels you can take down

Channels and clips let fabric and wood panels lift off for repainting or a move.

Also used for wall lights, screens, recovered panels and acoustic fixes in rented spaces.

Home cinema wall cut away to show its layers: bare wall, vinyl barrier, bass absorber and PET acoustic panels

Installation

Three layers, one quiet wall.

MLV Sound Barrier: Mass Loaded Vinyl barrier. Dense membrane that blocks airborne noise at the wall level. The primary noise-stopper. 2.5mm Sounds up to 90dB 4mm Sounds up to 120dB
Bass Absorber: High-density acoustic absorber. Kills low-frequency bass vibrations that MLV alone cannot block. Sits inside the wall. 20mm NRC 0.85 40mm NRC 1.00
PET Acoustic Panel: Visible finish layer. Controls room echo, covers the barrier layers, and transforms the wall into a premium interior surface. 9mm NRC 0.30, 100+ designs

Start here

Browse the range

Shop all hardware